Army Armament R30-3 GBB
The Army Armament R30-3 is a gas blowback pistol
R30-3
The R30-3 Gas Blowback Pistol is based on the 1911 Platform and is powered by a detachable Gas Magazine. The Slide and Frame are constructed from Aluminium Alloy.
The Pistol features a Threaded Outer Barrel with a Female 12mm CCW Thread for the installation of Suppressors, Tracer Units, and other Muzzle Devices (a Thread Adapter may be required).
The Slide has a set of 'Three Post Ironsights' and also features a Slide Lock safety which can be engaged to stop the Pistol from firing. The Beavertail Safety on the Pistol Grip also won't let you fire the Pistol unless it is being gripped properly. A Skeletonised Trigger and Hammer add to the tactical look, and reduce a tiny amount of weight, but is mostly about looking as tactical as possible. Finally, a Lanyard Loop can be found on the base of the Pistol Grip, which can be used as a secondary layer of security when sat in a Holster.
The Pistol features an Adjustable HOP Unit, which is accessed by removing the Slide from the Frame. To do this, you need to first remove the Magazine. Line up the Slide Release Lever with the smallest cutout on the Slide, and press it through from the other side. Once the Slide Release Lever is removed, the Slide should just run off the Frame forwards, and allow you access to the HOP Unit on the underside of the Outer Barrel Assembly. By adding HOP, you will make the BBs spin harder as they leave the barrel, helping them stay in the air for longer, especially when paired with the right settings and BB weight.
Included in the box is a 27 rnd Gas Magazine which is filled with BBs either by hand or using a Speedloader, from the top of the Magazine. A Gas Inlet Valve on the base of the Magazine is where Green Gas is to be inserted. Also included is an Instruction Manual.
Part Names
1
4
2
5
3
9
10
11
6
-
Front Site
-
Rear Site
-
Slide
-
Trigger Gard
-
Trigger
-
Grip
-
Magazine
-
Magazine Catch
-
Muzzle
-
Slide Catch
-
Safety
8
7
Whats In The Box?
-
1x R 30-3
-
1x magazine
-
2x Front and rear sites
How To Servis
-
Remove the slide you will first need to cock the R14, and then remove the magazine.
-
pull the slide back to align the slide lock with the rearmost notch in the slide.
-
push the slide lock out from the right side of the pistol
-
Push the slide toward the front of the pistol until it stops
-
Slightly lift up on the slide
-
Cearfly Remove the spring from inside the slide
-
Cearfly Remove the muzzle from inside the slide
-
Lubricate the marked points in the diagram below
